Window film gives your car windows a dark tint, providing greater privacy, reducing heat build-up inside the car and giving it a sleek look. You can fit the film yourself, but it’s important to bear in mind the legal requirements for light transmission. Below, you can read why window tinting is popular, which shades are permitted, what the MOT requirements are and how to fit the film step by step.
Why tint car windows?
Window film offers a combination of practical and aesthetic benefits. The dark tint gives the car a sleek, stylish look that works well with both light and dark paint finishes. In addition, the film makes it much harder to see in from the outside, whilst you can still see out just as easily. Many films also block up to 80% of sunlight, meaning the interior heats up less quickly and you don’t need to use the air conditioning as often. Finally, the film protects the upholstery from fading in the sun and reduces glare from the bright headlights of oncoming traffic.
What shades of window film are available?
Window film is available in various degrees of light transmission, expressed as percentages: the lower the percentage, the darker the film. The most common types are 5%, 20%, 35%, 50% and 70%. A 5% film lets through virtually no light and is only suitable for the rear windows, whilst 70% is barely visible and suitable for the front side windows. The most extreme variant, 3%, makes it almost impossible to see inside from the outside, but may only be applied to the rear windows.
Legislation: which windows are you allowed to tint?
The legislation sets requirements for the minimum light transmission per window. The windscreen must maintain a minimum light transmission of 75% and the front side windows a minimum of 70%, as good visibility in these areas is essential for road safety. There are no light transmission requirements for the rear side windows and the rear window, but as soon as you tint them, it is compulsory to have a right-hand wing mirror. Bear in mind that the manufacturer may have already applied a light tint to the windows, which means the tint film may need to be less dark than you might expect. The police can measure the light transmission on the spot and will issue a fine if the windscreen or front side windows allow less than 55% to pass through.
MOT requirements for tinted windows
During the MOT test, light transmission is not specifically measured, but the inspector does assess whether the driver has a clear view of the outside. Objects that restrict visibility, including window film that is too dark on the windscreen and front side windows, may result in the vehicle failing the test. In practice, this means that the film on the front windows must allow sufficient light through to enable safe driving. The rear side windows and rear window are not assessed in this regard, provided that the wing mirrors are present and in good condition.
Fitting window film yourself: a step-by-step guide
Applying window film is a precise job, but with the right preparation, it’s something you can easily do yourself. It’s best to work indoors or in the shade, as direct sunlight causes the film to dry too quickly. Follow these steps for each window:
- Clean the window thoroughly with a glass cleaner and remove all dirt and grease. Make sure the window is completely dry, <liMeasure the window with a tape measure and cut the film to size, leaving an extra 2 centimetres on all sides,
- Spray water onto the outside of the window and place the film over it so that you can cut out the exact outline,
- Spray the inside of the window with a mixture of water and a drop of washing-up liquid,
- Remove the protective film from the sheet and spray the adhesive side with the same mixture as well,
- Apply the film to the inside of the window, working from top to bottom,
- Use a spatula to smooth the cling film from the centre towards the edges to remove any air bubbles and water,
- Cut the remaining edges neatly with a sharp knife;
- Check for any remaining air bubbles and remove them with the spatula.
Once the film has been fitted, leave it undisturbed for at least a week: do not open the windows, do not use the rear window heater and do not clean the windows. The film needs this time to bond fully.
Need window film or parts? Japoto is here to help
At Japoto, you’ll find Parts for Japanese and Korean brands, with over 70,000 items in stock. Do you have any questions about which products are suitable for your car? Please contact or send an email directly to info@japoto.nl.